I believe using force is not an option as it contains carbonated beverage.
I would strongly advise against using sharp objects (like screwdrivers) to make a hole that is different in shape from the intended opening. It could result in small bits of aluminium (that the can is made of) falling into the contents, and possibly cause harm if ingested.
Just simulate the usual way of opening cans using a spoon handle or a similar non-sharp object in the same motion as the original tab.
Lay a teaspoon on the hole, face-down, keeping the tip of the head against the edge of the tab/hole.
Apply pressure to the middle of the head of the spoon.
This will push the tab into the hole, in much the same fashion as the actual ring pull would.
Take care to only press on the middle of the head of the spoon - stay away from the edges, otherwise your finger may slip into the hole when the tab gives way (which nobody wants).
OK, you all have no clue about how to do this. Get a blunt plastic object, like the base of lighter (I can guarantee that that will work) and then place it against the outside edge of the scored tab (bit that pops down) and then rub back and forth while applying medium pressure. The tab will burst open (be warned, it makes one hell of a bang). The drink remains carbonated and won't fizz over.
- Take a pair of pliers or like tool and grab what is left if the tab. With these pull upwards and open the can. It make a few trys and ruin the can, so drink the soda out of a cup to avoid messing with your mouth.
P-38 can opener.
All pictures taken from Wikipedia.org. Shown to demonstrate types of can openers available to use.
- Use a can opener. You can avoid all of the situation by just opening the can with a can opener. There are portable can openers(p-38 can opener is a really small one) so you are always ready.
Some forceful methods:
Use a sharp object, I.e. a screwdriver or other clean sharp object to poke a hole in the can. Be very careful, and direct the object away from your body. Make sure the object is clean.
Take a sturdy blunt object and place it on the tab. Then apply force, the tab should fall in making the contents accessible.
Some other helpful advice can be found on this site.